Electric Gate Repair in Riverside & the Inland Empire
When an electric gate quits, everything stops with it. Cars pile up in the driveway, a business loses its first line of security, and an HOA gets a flood of calls before lunch. Electra Gate Solutions fixes electric gates fast – swing or slide, residential or commercial – across Riverside, San Bernardino, Ontario, Rancho Cucamonga, Corona, Colton, Moreno Valley and the surrounding Inland Empire. We’re fully insured, available 24/7, and we’ll give you a straight, upfront price before any work begins.
The problem / what we do
Most gate failures trace back to a handful of usual suspects. The good news: nearly all of them are repairable, and you rarely need a whole new system. Our technicians diagnose and repair:
- Control boards – fried logic boards, blown fuses, water-damaged terminals, and faulty wiring.
- Gate motors and operators – humming-but-not-moving motors, worn gears, seized arms, and overheating units.
- Safety sensors (photo eyes) – misaligned, dirty, or dead sensors that make a gate reverse or refuse to close.
- Loop detectors – buried exit and safety loops that stop seeing vehicles.
- Limit switches – gates that overshoot, stop short, or never know where open and closed are.
- Chains, rollers, hinges and track – the mechanical parts that bind, sag, jump the track, or grind.
- Power and battery issues – no power at the operator, dead backup batteries, blown transformers, and tripped breakers.
Whether your gate won’t open, won’t close, opens halfway and stops, beeps and reverses, or moves in slow motion, we’ve seen it and fixed it.
Our diagnostic process, step by step
1. Confirm power and safety first. We verify the operator is getting clean power and that the gate can be safely operated by hand before anything else. 2. Reproduce the fault. We run the gate through full open/close cycles to watch exactly where and how it fails. 3. Test the brain. We check the control board, fuses, and wiring for shorts, corrosion, and failed components. 4. Check the senses. We align and test photo eyes, then test loop detectors and limit switches. 5. Inspect the muscle. We examine the motor, gears, chain or rack, rollers, hinges, and track for wear and binding. 6. Quote, then repair. You get a clear price up front, then we fix it, re-test the full cycle, and confirm every safety feature works.
Built for Inland Empire conditions
Gates out here take a beating that coastal gates never see. Triple-digit summer heat cooks control boards and bakes lubricant out of hinges and chains. Fine Inland Empire dust drifts into photo-eye lenses and motor housings until sensors go blind. Santa Ana winds twist gate frames and knock photo eyes out of alignment overnight. We account for all of it so the repair lasts past the next heat wave.
FAQ
My gate beeps and then reopens instead of closing. Why? That’s almost always a safety sensor or loop fault – a dirty, misaligned, or failed photo eye, or a loop detector that thinks something is in the way. One of the quickest fixes we do.
Can you repair my gate the same day? Often, yes. We carry common boards, sensors, and hardware, and we’re open 24/7.
Is it cheaper to repair or replace my opener? Repair usually wins. If your operator is older and failing repeatedly, we’ll walk you through gate opener and operator installation options – no pressure.
Do you work on both swing and slide gates? Yes – single and dual swing gates, and rolling slide gates of all sizes.
Get your gate moving again
Don’t fight a stuck gate. Electra Gate Solutions repairs electric gates across the Inland Empire with fast response, insured technicians, and honest pricing. We also handle gate access control and telephone entry and full commercial gate service. Call (951) 903-5514, request a free quote, or contact us anytime – day or night.